Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.www.tormek.com
Started by Sam Sloane, March 12, 2019, 01:43:15 PM
Quote from: Sam Sloane on March 12, 2019, 01:43:15 PMMorning All,I do my bevel grinding on a Tormek T8, but wanted a better faster way to finish the edge.I have a brand new Paper Wheel set up now, but having never seen one LIVE, I am thinking there must be tricks to getting them running true, better than what I have. If videos would be helpful, I could post them, to see what I have....I have a 3/4 Hp dual ended Buffer variable speed.Main Shaft is 20mm, with 5/8" dia for mounting 10" wheels.I have flattened the wheels as best I can by clamping for a few daysI replaced the cheap pressed washers with 0.375" thk steel washers, lazer cut.I block sanded the out diameter of the paper wheels to try to true the ODsThe result works, but I did expect better results....the knife blades still "bump" along while honing.....I wasn't expecting a super balanced result, but I did think it would be better!Any suggestions?SamPic attached....
Page created in 0.050 seconds with 21 queries.