Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.www.tormek.com
Started by Badassblades, April 17, 2017, 01:19:56 AM
Quote from: Herman Trivilino on May 17, 2017, 03:44:24 AMI use a the SVM-45 knife jig to sharpen my mower blade on the Tormek. If I need to remove a lot of steel I'll go back and forth between a dry grinder and the Tormek. It helps keep the blade cool.I've been doing it this way for many years now. Sharp blades do a much better job of caring for the lawn.
Page created in 0.017 seconds with 19 queries.