Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.www.tormek.com
Started by Jan, January 23, 2017, 05:26:50 PM
Quote from: Jan on January 24, 2017, 01:40:42 PMFor me the secondary bevel is visible by the necked eye while the micro-bevel is not. Jan
Quote from: WolfY on January 26, 2017, 05:00:23 AMI would always assume there is a micro bevel when there is a scandi grind. Otherwise the edge would be to vulnerable. The visibility of it depends on how far up on the secondary it is placed and if it is straight or convex bevel. The convex is difficult to distinguish. Also the convex will not reflect the laser so you can measure it right.
Quote from: Jan on January 26, 2017, 10:20:18 AMWolfy, my devices are built from MERKUR which is a Czech toy metal construction set. http://www.merkurtoys.cz/en/
Page created in 0.048 seconds with 19 queries.