Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.

Main Menu

a new angle setting tool

Started by Ken S, October 19, 2015, 08:12:09 PM

Previous topic - Next topic

Sir Amwell

And me!
As I said before somewhere on the forum, a self centering, adjustable ( in terms of projection) jig would be ideal. It can't be difficult to achieve surely?
I had considered cutting off the self centering clamp off the new KJ and welding it to the clampless shaft of the old SVM jig ( ie the clamp removed with a hacksaw).
Ho hum..............