Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.www.tormek.com
Started by casher50, October 16, 2019, 04:14:20 AM
Quote from: casher50 on October 16, 2019, 04:14:20 AMNow my first Tormek related question. 1) I have unintentionally created a couple of these "impossible" burrs on my T4 and have the same problem. The honing wheel will not remove the burr. What do you suggest? 2) Will any light machine oil work on the honing wheel (3 in 1 oil perhaps) and how often should I apply it? 3) How often should I apply the grit cream to the honing wheel and should I let it soaking for a while before using the wheel? 4) Since the grading stone changes the grinding wheel from 220 to 1000 grit, does the wheel's grit vary between the two? In other words, at some point is the grinding wheel's grit rating say, 600 or some other in-between grit? If so, how would we figure out what it actually is?
Page created in 0.013 seconds with 20 queries.