Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.www.tormek.com
Started by wootz, August 02, 2015, 02:14:37 PM
Quote from: Stickan on August 04, 2015, 01:20:05 PMWootz, Please check if the edge is actually in the middle of the blade aslo!Best , Stig
Quote from: wootz on November 04, 2015, 04:43:26 AMI realized the problem with adjustments every time as the knife is flipped over, is that when I have to alternate sides, it is impossible to maintain strictly the same angle, and because of that I cannot get sharp edge.I ended up by buying a second knife jig, and filing away 1 mm from the static clamp. Now I have a dedicated jig for knives 3mm and over thick.Not that I recommend this to everyone, but if you sharpen many thick knives, this helps to minimize the bevel asymmetry.
Page created in 0.036 seconds with 19 queries.