News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

What about Draw Knives?

Started by PapaDoc, July 20, 2005, 11:45:43 PM

Previous topic - Next topic
Print
Go Down Pages1
User actions

PapaDoc

July 20, 2005, 11:45:43 PM
What is the best method for sharpening drawknives?
David

Jeff Farris

#1
July 21, 2005, 03:53:09 PM
As shown on page 121 of the Owner's Handbook, drawknives are sharpened with the regular knife jig (SVM-45) with the Universal Tool Support in the horizontal position.
Jeff Farris
Print
Go Up Pages1
User actions