News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.

www.tormek.com

Main Menu

Tormek US-105 universal support with micro adjust nut

Started by jeffs55, July 09, 2011, 02:06:03 AM

Previous topic - Next topic
Print
Go Down Pages1
User actions

jeffs55

July 09, 2011, 02:06:03 AM
Does the Tormek made device described above have a "flat" on one side of one of the supports?

What is this piece of metal made from? Stainless steel or plated steel?


You can use less of more but you cannot make more of less.

Jeff Farris

#1
July 09, 2011, 03:18:29 AM
The newest version is stainless, without a flat milled on the rod. The top of the thread is flat, so the clamp will not distort the thread. The previous version had a milled flat section.
Jeff Farris
Print
Go Up Pages1
User actions