News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

How Much Time Turning a Piece?

Started by GIPPER, July 05, 2011, 10:40:31 PM

Previous topic - Next topic
Print
Go Down Pages 1 2
User actions

Ken S

#15
July 15, 2011, 07:49:37 PM
Jeff, I think you are probably right about the roughing gouge being used too far from the tool rest.The tip was out of line by about 3/4" when I bought it.  I will be mindful when using it.  I intend to use primarily the larger gouge.  The smaller gouge was just part of the package.

Ken
Print
Go Up Pages 1 2
User actions