News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Angle when sharpening a chisel

Started by jimprater, April 22, 2010, 09:13:33 PM

Previous topic - Next topic
Print
Go Down Pages1
User actions

jimprater

April 22, 2010, 09:13:33 PM
Even though I have the chisel straight in the holder (checked with square), and the wheel is true, I get an angle on every chisel I try to sharpen.  It's small, but the edge is never square.  What am I doing wrong?

Jeff Farris

#1
April 23, 2010, 02:18:56 AM
Jim,

Which model jig are you using?  SVH-60 (old) or SE-76 (new)?
Jeff Farris
Print
Go Up Pages1
User actions