News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

End Mill Sharpening

Started by George, February 17, 2024, 05:05:14 PM

Previous topic - Next topic

George

I have just taken delivery of my new Tormek system and must say WOW what a great looking product. Precision made well documented and worth the money spent.

So that's the nice bit done. Here's the question.

Do Tormek plan in introducing an End Mill cutter sharpener accessory?

A breeze to use. :D

John_B

I would contact support and ask them. They will have more insight than us users.
Sharpen the knife blade
Hone edge until perfection
Cut with joy and ease

TheSeldomSeenKid

I would doubt it (but I could be entirely wrong). Reasons: limited market, complexity, required rigidity and precision.
Note:
I own a dedicated end mill sharpener and its fairly involved (conical diamond wheel, air spindle, collets to maintain concentricity, carriage, flute indexing, etc..).