News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

turning cutters

Started by briandavies, February 14, 2007, 08:39:14 PM

Previous topic - Next topic
Print
Go Down Pages1
User actions

briandavies

February 14, 2007, 08:39:14 PM
Hi
I use my tormek for sharpening woodturning and wood working tools
and was wondering could i use the tormek to take a very slight chip out of a metel turning cutter
thanks

Jeff Farris

#1
February 15, 2007, 04:24:54 AM
As long as it is not carbide, it should cut it fine.
Jeff Farris
Print
Go Up Pages1
User actions