News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Bottom bowl gouge

Started by turnedbykyle, October 02, 2014, 05:25:27 AM

Previous topic - Next topic
Print
Go Down Pages1
User actions

turnedbykyle

October 02, 2014, 05:25:27 AM
I did do a search, and could not find any info......

How do you set a 75 degree bevel angle on the 185? I'd like to try a bottom feeder gouge. The instructions say use P65, JS 4 but it's the same for all the angles... That's what I use now, and it's not 75 degrees.

TIA
Print
Go Up Pages1
User actions