News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

filet knives

Started by thats sharp, September 04, 2014, 03:12:33 AM

Previous topic - Next topic

thats sharp

Anyone have ideas on how to get a good sharpening on a thin blade fillet knife? I have tried to use both the short and long jigs and also purchased the extra jig for smaller knives but I cannot seem to get the angle sorted out. I seem to always be making contact between the jig and wheel.
Can an extension of some sort be added to one of the jigs which would allow the knife to stay ahead of the jig? I'm seeing a lot more of these knives since our salmon season has arrived. Not complaining tho....

grepper

#1
Welcome to the forum, thats sharp!

You will be glad to know that is a very well known and extensively discussed issue here.  Search the forums for even more info.

Three solutions:

Tormek Small Knife Jig:
http://tormek.com/international/en/grinding-jigs/svm-00-small-knife-holder/

Ionut-Herman tool rest:
http://forum.tormek.com/index.php?topic=1592.msg6634#msg6634

Do it by hand.



jeffs55

Those long tapering blades on the cheap Finnish knives like you buy at Wally World really have to be done by hand.
You can use less of more but you cannot make more of less.