News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

motor won't turn

Started by krae, January 04, 2014, 10:57:36 PM

Previous topic - Next topic

krae

I have a Tormek 2000 and the motor is frozen. There is no movement at all. I have tried to remove the motor from the machine but one of the mounting screws is located under the pivot shaft of the mounting hardware. Is there a trick to remove this? Thanks in advance for any help.

Herman Trivilino

Can't you remove the pivot shaft itself?  Mine appears to have a cap nut on one end.
Origin: Big Bang

Jeff Farris

The pivot pin doesn't have a cap nut. It is a press fit. Tap the bullet shaped end and the pin will come out, allowing the motor to separate from the frame.
Jeff Farris

krae

Thank you for the advice. The pin tapped out. Now, lets hope I can get the motor to work.