Hi all
I use a drill with this particular tip geometry (photos attached) and it works great for me.
What I wonder is if I could sharpen this on the Tomak, I do not think the DBS-22 can do it.
The part that worries me the most is the sharp corner in the center.
I am considering 3D printing a simple custom jig and see if I can make that work.
The surface Marked A is concave and the surface marked B is convex.
Any suggestions are much appreciated.
All my best
Per
I use a drill with this particular tip geometry (photos attached) and it works great for me.
What I wonder is if I could sharpen this on the Tomak, I do not think the DBS-22 can do it.
The part that worries me the most is the sharp corner in the center.
I am considering 3D printing a simple custom jig and see if I can make that work.
The surface Marked A is concave and the surface marked B is convex.
Any suggestions are much appreciated.
All my best
Per