Messages

I guess, I can try to figure it out. That is where Tormek can help.

@Tormek folks. Do you have a 3D model of KJ-45 somewhere?

Thank you.

Hi team!

I wonder if we have anyone equally good with 3d printing and sharpening. I was thinking about a better version of a jig that Vadim used for the protrusion measurement.

I envision it as a block, with subtracted KJ-45 and a dip for the knife spine on a fixed distance from the KJ jaws. With moving block, for the edge, that goes parallel to spine dip. Ideally with a ruler or a place to attach a ruler or calipers.

I never worked with 3d before, so it will take a bit for me to figure it out. If we have more experienced 3d people here, it might go way faster.

I want to use a wheel hook similar to TS-740 with a Husky/Seville/HomeDepot bench or cabinet. Something like wall plate with baby stud in photo lighting:


Anyone have any ideas what we will be a good candidate for this DIY?

Thank you.

I found it: http://knifegrinders.com.au/Shop-software.htm
It was at the very bottom of the page.

Hi there! I bought a wrong thing from Vadim's site: http://knifegrinders.com.au/11Shop.htm
It is a bench grinder edition and I was looking for a Tormek one. I can't find the link to buy it anywhere.

Please let me know if you have a link saved somewhere

Thank you.
Sergei