In the quest to save my back and stop utilizing an hour on each one of the day unpacking setting up a 10x10 ez-up tent and three table and all my machines, and stay out of the elements, necessary to maintain my itinerant business model.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Knife Sharpening / Giving back
October 06, 2022, 10:23:05 PM
Doing a thing, sharpening for the patron of the community food pantry.
#3
Knife Sharpening / Sharpening an Ulu?
September 04, 2022, 10:45:46 PM
Got a job in that had befuddled me as to how to jig this up, any ideas vs freehand?
#4
General Tormek Questions / Running on inverter?
September 04, 2022, 09:32:37 PM
I have been invited to attend a potentially lucrative (and excellent advertising/marketing opportunity) event but they have no ground power and a generator to the site is not permitted.
Need to run potentially (2) T-8's for 4 hours. (Worst case) v=i*r ?
Need to run potentially (2) T-8's for 4 hours. (Worst case) v=i*r ?
#5
General Tormek Questions / The Farmers Market Hustle
September 03, 2022, 10:18:18 PM
Just sharing a day in the life if a farmers market sharpening service...
Best advertising/exposure you can get for $75/year, IMO.
Pain I. The back to move it all a few times a week, though.
Best advertising/exposure you can get for $75/year, IMO.
Pain I. The back to move it all a few times a week, though.
#6
General Tormek Questions / T-8 Custom build….
August 26, 2022, 11:23:56 PM
Might folks like to vicariously enjoy my T-8 Custom build?
Goods for the T-7 and a new T-8 Custom today ...
Goods for the T-7 and a new T-8 Custom today ...
#7
Knife Sharpening / Honing progression
August 25, 2022, 10:05:28 PM
Really fell in love with the composite wheel on my T-2 so much I ordered a CW-220 composite wheel along with my new T-8 Custom (drive-by gloat). Got me thinking about my honing procedure, and how I can increase edge quality, and customer satisfaction, and make my life easier?
So I'm thinking ; CW-220 , LA-220 with PA70, and LA-220 with Chromium Oxide, should be about right?
So I'm thinking ; CW-220 , LA-220 with PA70, and LA-220 with Chromium Oxide, should be about right?
Pages1