News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - SRT.cni

#1
Tormek T-1 and T-2 / leather honing wheel
August 14, 2022, 09:53:53 PM
Hi All out there.
I just thought I would put my nose into the forum.
On my old m/c I decided to make a modification by making a new stainless steel main shaft no more rust problems changing the wheel ( annealed 440C )to carry the wheels and instead of having the leather honing wheel on it both ends can carry a regular or diamond wheel. Now I have a 300 grit CBN wheel on one end and a 1200 grit cbn wheel on the other.
So far I am well pleased with the new setup as the 1200 grit wheel is almost as good as the leather one but then times quicker.
Your thoughts on this. I only sharpen my knives and chisels etc no business involvement.