I use the Triton style knife jig and as posted in earlier threads, this has zero offset and this is problematic on thicker blades.
A solution I am trying is to 3D print a collar that goes over the shaft that has basically a crescent shaped portion on one side of shaft, with thickness equal to blade thickness being held.
Example my prototype has a 2 mm thick crescent for 2 mm blades. This shifts effective jig centre line by 1 mm to centralise blade. The outside radius of crescent portion is same radius as shaft, so no issues with any tilting to sharpen tip of blade etc.
These images might assist.
A solution I am trying is to 3D print a collar that goes over the shaft that has basically a crescent shaped portion on one side of shaft, with thickness equal to blade thickness being held.
Example my prototype has a 2 mm thick crescent for 2 mm blades. This shifts effective jig centre line by 1 mm to centralise blade. The outside radius of crescent portion is same radius as shaft, so no issues with any tilting to sharpen tip of blade etc.
These images might assist.