News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Petter

#1
I posted this on the newbie forum (Tips and tricks) and got kind responses and was asked to repost here. Anybody have these constants for T-4?

I am a total newbie and I am trying to use TormekCalc for T-4 but none of the constants are available for that machine.

Looking for constants for T-4: VH, HH, HV, VV as shown in the attached drawing

jvh kindly responded: "From some older notes I have:  VH=66  HH=29  HV=50  VV=20.  (I didn't double check... so do some testing to verify).

Also just so you know, you can use the "T USB" measurement... which measures from the top of the USB to the top of the wheel... that measurement doesn't need the machine measurements.  (The machine measurements only matter if you're setting the USB by measuring to the machine).  :)"
#2
I am a total newbie and I am trying to use TormekCalc for T-4 but none of the constants are available for that machine.

Looking for constants for T-4: VH, HH, HV, VV as shown in the attached drawing