Messages

I was about to start on a small cabinet (with drawers for the jigs, etc) with casters. I think the height will be too much for comfortable sharpening.

The hydraulic lift stand may be the ticket, although no drawers.

I am so glad I was able to get to this forum. The knowledge and experience with Tormek sharpening has greatly helped in a short amount of reading!

Smarter, not harder!

I just purchased the tool in this thread. I think it's going to help using the angle program in Cbwx34's signature line.

I've been marking the blade with a sharpie since getting my Tormek. Hope this tool helps in USB adjustment.

The Tormek tool (for me) is a little vague in precision.

cbwx34, thanks for the link to the newer video. Got the tool in the mail today and can't wait to use it.

Does anyone know where else to find one of these? It's not showing up on the eBay page.