Hi again.
Ken, will the T4 take the same wheels as the T3?
Cheers.
Bob
Ken, will the T4 take the same wheels as the T3?
Cheers.
Bob
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
#122
General Tormek Questions / grinding stones
April 05, 2015, 01:26:53 PM
Its bob again.
Thanks Ken for your last piece of info which was a big help and appreciated.
Heres another one.
Is it poss to use the T3 grinding wheel on the T7 machine ?
Thanks Ken for your last piece of info which was a big help and appreciated.
Heres another one.
Is it poss to use the T3 grinding wheel on the T7 machine ?
#123
Planer Blade Sharpening / Re: planer blade jig
April 05, 2015, 01:22:32 PM
Thanks a lot Ken. You have just saved me about 100 Quid.
Cheers.
Bob
Cheers.
Bob
#124
Knife Sharpening / carving / hamslicer knives
April 04, 2015, 10:25:50 PM
Hi,
is it possible to sharpen carving knives ( non serrated ) / ham slicing knives. 8 inch - 10inch - 12inch blades on the long knife jig
or would it work better on the planer blade jig?
I look forward to the replies.
Cheers.
Bob. U.K.
is it possible to sharpen carving knives ( non serrated ) / ham slicing knives. 8 inch - 10inch - 12inch blades on the long knife jig
or would it work better on the planer blade jig?
I look forward to the replies.
Cheers.
Bob. U.K.
#125
Planer Blade Sharpening / planer blade jig
April 04, 2015, 10:19:19 PM
Hi,
can I use the planer blade jig to sharpen 8 inch - 10inch - and 12inch non serated / ham carving knives, or is this possible on the long jig for knives.
Thanks.
I await a reply with eagerness.
Cheers.
Bob
U.K.
can I use the planer blade jig to sharpen 8 inch - 10inch - and 12inch non serated / ham carving knives, or is this possible on the long jig for knives.
Thanks.
I await a reply with eagerness.
Cheers.
Bob
U.K.