Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.

Main Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Marty

  Is there a design flaw with the blade holder jig for sharpening jointer blades ?  I am trying to sharpen 5/8 inch wide blades (supposed to be able to sharpen minimum 1/2 inch width blades ) at a 30 degree angle,  and when I try to sharpen, the blade holder scrapes on the grinding wheel before the edge is sharpened even close.  My grinding wheel is not that old, only worn down about 3/8 inch from original diam.???