OK
Thanks Jeff
Thanks Jeff
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
#76
Planer Blade Sharpening / Re: Tilt Shoes & Water Chute for Long Tools
January 11, 2011, 06:17:55 AM #77
Planer Blade Sharpening / Tilt Shoes & Water Chute for Long Tools
January 10, 2011, 03:04:22 AM
Has anyone noticed that the Tilt Shoes are not quite enough tilt to prevent water dripping off to the left onto the housing?
I added a 1/4" spacer to lift the left a little more & that seams to be enough to keep the water at bay.
Dan
I added a 1/4" spacer to lift the left a little more & that seams to be enough to keep the water at bay.
Dan
#78
General Tormek Questions / Re: Tormek Original Grindstone SG-250
January 08, 2011, 06:14:57 PM
Thanks Ionut
That makes sense.
That makes sense.
#79
General Tormek Questions / Re: Tormek Original Grindstone SG-250
January 07, 2011, 09:09:05 PM
Thanks for the fast reply Jeff.
I will remove the Water Trough when not in use.
Dan
I will remove the Water Trough when not in use.
Dan
#80
General Tormek Questions / Tormek Original Grindstone SG-250
January 07, 2011, 06:45:08 PM
Hello Tormek users.
I have a question about the Tormek Original Grindstone SG-250.
I have noticed that my stone goes out of round after a day or two.
The stone seemed to be in good shape when last used but the next time I use it it needs to be trued using the Truing Tool.
To test my situation I trued the stone at the end of my sharpening session & after a day or two tested it & sure enough it was out of round again.
The one thing that comes to mind is that it may be happening because the bottom of the stone is in water causing it to change shape from the difference in watter content from the top being dry & bottom being wet.
Has any one noticed this?
Should I remove the Water Trough when not in use?
Thanks
Dan
I have a question about the Tormek Original Grindstone SG-250.
I have noticed that my stone goes out of round after a day or two.
The stone seemed to be in good shape when last used but the next time I use it it needs to be trued using the Truing Tool.
To test my situation I trued the stone at the end of my sharpening session & after a day or two tested it & sure enough it was out of round again.
The one thing that comes to mind is that it may be happening because the bottom of the stone is in water causing it to change shape from the difference in watter content from the top being dry & bottom being wet.
Has any one noticed this?
Should I remove the Water Trough when not in use?
Thanks
Dan