You do all the vids and probably trade shows and demos. How small of a wheel have you used? I mean how small in diameter was the smallest wheel you have used? Have you used one to such a size that it was no longer usable? thanx
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
#21
General Tormek Questions / how small of a grinding wheel have you used Jeff Farris
February 08, 2011, 01:42:49 AM #22
General Tormek Questions / long knife jig
November 24, 2008, 02:38:09 PM
What is the difference between the SVM 100 and the SVM 140 other than the 100 being discontinued?
#23
General Tormek Questions / super fine grade stone
June 24, 2008, 02:40:25 PM
I bought a supposedly 4000 grit Japanese waterstone for my Tormek. That sucker wobbled terribly after mounting . I checked the arbor and the bushing that the drive shaft goes through was flat to the frame. I put the original Tormek stone back on and it did not wobble. It didnt wobble before removal either. The company that I got the waterstone from agreed to send a replacement immediately, even before they got mine back. My question is does Tormek produce another stone of this fine a grade just in case that the replacement is no good either. Finally, if my tormek stone does not wobble am I correct in assuming that the other stone was defective? thanx