Samething happens to me using T4. And I was doing longer kitchen knives
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Hand Tool Woodworking / Re: How to make chisel edges square
April 15, 2023, 02:10:23 PM
defintely won't use truing tool on dimaond stones. Reason i asked is that on my T4 one side of the diamond stone is plastic that goes towards the motor so wasn't sure if thats a good reference point
That little square is nice, I ended up getting one from amazon. tiny japanese machinist square, seems to work great.
That little square is nice, I ended up getting one from amazon. tiny japanese machinist square, seems to work great.
#3
Hand Tool Woodworking / Re: How to make chisel edges square
April 14, 2023, 02:38:34 AM
Can this procedure be used with diamond stones?
Pages1