On a few occasions I have inadvertently knocked over one of my Tormek stones during a sharpening session. I just completed a small stone storage rack build that should avoid this problem in the future. Very simple build and all made from scrap 2x4's and 2x2's. Dimensions are shown in the attached picture. Just thought I would share in the even someone else would like to build something similar.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com