News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - mbowline

#1
General Tormek Questions / Stuart Batty Angle Gauge
November 17, 2022, 04:33:19 PM
I'm beginning to venture into grinding a negative rake scraper along with other scrapers, too. I've watched many videos that show various methods to set the angle of the tool rest.

I have found the Stuart Batty Angle Gauges as an intriguing option.

My question to the Forum is this: will an angle gauge such as the Batty ANgle Gauge work on my Tormek 2000?