Hi I am sure this question has been asked many many times but I will ask again. Can anyone tell me the thread size for the adjusting nut for the support arm. When Googled it comes up as ACME and I know the bar size is 12mm but no further info can I find. I am trying to take the slack out of the support arm by adding a second nut on the base.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com