Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.

Main Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - Edwe


I have som problem with narow knifes like file or fishing knifes that the the lengt of the SVM-45 Jigg isnt long enough.
Any ideas on that?
Knife Sharpening / How to make a honing stand for t4
January 26, 2019, 03:13:08 PM
I want to move the support bracket over to the other side and use the SVM-45 Jigg to have the correct angle when honing. Is there a way to do that?