I was wondering when to replace a stone grader
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Knife Sharpening / just watched jeff on youtube
November 16, 2014, 01:23:33 AM
He gets that knife razor sharp, mine get sharp but not like that. Will i become a jedi sharpener with time? It can get frustrating i guess practice makes perfect
#3
Knife Sharpening / sharpening fillet knife
November 14, 2014, 10:54:13 PM
I set my angle at 15 and still can not get a sharp edge, it's a gerber and i graded the stone to fine, is it me or are these really hard to sharpen 
#4
Knife Sharpening / question for herman
November 14, 2014, 03:04:09 AM
I WAS WATCHING YOUR VID ON YOUR JIG YOU MADE, AFTER YOU SET THE ANGLE DO YOU HAVE TO RESET FOR BLADE THICKNESS? I LOVE THE JIG I WOULD SAVE ALOT OF TIME AND I WOULDN'T RUN MY HAND INTO THE STROP WHEEL ANYMORE.
TOM BOYD
TOM BOYD
#5
Knife Sharpening / knife jigs
November 13, 2014, 12:55:21 AM
I just received a sm45 jig and the handle always wants to unscrew or screw in changing the blade angle. Is it me or is this jig messed up. all the vids i see they have a locking screw, not mine.
Pages1