News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.

www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - Tony29

#1
Wood Carving / Flexcut and the SVS-32
October 22, 2012, 05:03:53 AM
I tried to sharpen a Flexcut regular sweep gouge with the SVS-32 jig.  Because the gouge has a flat shank, it did not roll evenly and did not follow the sweep of the bevel.  How do I sharpen the Flexcut gouges???
#2
Hand Tool Woodworking / Square Edge jig
May 22, 2010, 12:36:10 AM
I've had issues getting square grinds on my chisels using the SVH-60 jig, even when following the tech bulletin on properly tightening the jig.  Is there any advantage to using the SE-76 Square Edge Jig?
#3
Planer Blade Sharpening / Indexed planer knives
May 22, 2010, 12:09:29 AM
I have a Dewalt 735 planer and it has indexing knives.  Can they be sharpened on the Tormek?  My concern being that you can't adjust the knife position in the cutterhead.

If it is possible to sharpen them on the Tormek, does anyone have experience putting a steeper angle on the knife?  I'm considering running some birdseye maple and trying to stave off tearout.