- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Re: Rotating Base Problem
November 22, 2021, 12:27:23 AMQuote from: Edge-Master on November 17, 2021, 12:12:31 AMany rust?
I got some WD 40 into the area of the center---used a tube and had access; just a little squirt. It now rotates but is very stiff. I am still going to take it apart and add a teflon washer and the silicone grease.
Thanks to all. Mike ( my lifelong nickname )
#5
General Tormek Questions / Re: Welds on US-430 extended support
August 30, 2020, 12:27:03 AMQuote from: jvh on August 26, 2020, 03:34:56 PM
Hello,
I've just got final reply from Tormek support and they will replace my US-430, because it is not supposed to be like that.
What a support! Thank you very much guys.
jvh
Good service like that is rare these days
Pages1