News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Rqualls

#1
Hi, new member and new to using the Tormek.

I have not tried it yet but see that the scissor sharpening jig is not really allowing me to get the proper angle on my wife's really small scissors that she uses to cut thread while crocheting. The scissors are so small that there is not enough blade protruding from the jig to allow for the 20 degrees or so that it has on it (they are cheapies and the original grind is horrible!)

Any solutions to this? I was thinking perhaps grabbing onto the handle instead of the actual blade, as shown in the videos  but thought to ask here of there any of you have a better solution to this.

Thanks!