Thanks Jeff, I just gave it a try & it worked like a charm.
PS. Your video which came with the system is great and has been a huge help.
Thanks again.
PS. Your video which came with the system is great and has been a huge help.
Thanks again.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Wood Turning / 1/4" gouges in SVD-185
May 13, 2008, 07:27:43 AM
Hi,
I'm a new user. ' just setting up this weekend. So far so good but one question. How do you mount 1/4" gouges in the SVD-185? Do you remove the pad/guide bar in the same way that you do for the SVS-50?
Thanks
Jeff
I'm a new user. ' just setting up this weekend. So far so good but one question. How do you mount 1/4" gouges in the SVD-185? Do you remove the pad/guide bar in the same way that you do for the SVS-50?
Thanks
Jeff
Pages1