I'm new at this so maybe I was not as clear as I should have been on the explanation of the wobble problem.
I was indeed talking about honing wheel wobble.
The washer I referred to is the washer between the shoulder of the axle and the drive wheel which "drives" the honing wheel.
According to the parts view and list for the Model 2000 on the Sharptool website, the washer is number 30 and, at least on my machine, is not stainless. It appears to be a stamped washer and there was a problem in stamping making it not flat. The replacement part cost of .20 also would lead me to believe that a replacement would not be stainless either.
The washers on the sides of the wheel are stainless. I checked.
I was told the machine was "current" up until the Model T-7 came out so it is not that old.
The discussions and information on this forum are an incredible resource.
I was indeed talking about honing wheel wobble.
The washer I referred to is the washer between the shoulder of the axle and the drive wheel which "drives" the honing wheel.
According to the parts view and list for the Model 2000 on the Sharptool website, the washer is number 30 and, at least on my machine, is not stainless. It appears to be a stamped washer and there was a problem in stamping making it not flat. The replacement part cost of .20 also would lead me to believe that a replacement would not be stainless either.
The washers on the sides of the wheel are stainless. I checked.
I was told the machine was "current" up until the Model T-7 came out so it is not that old.
The discussions and information on this forum are an incredible resource.