Messages

Thanks for the reply.

Been there, done that - still won't fit.
I could open up the "v" end of the jig with a file.
Perhaps I will. Do you sell this part of the jig as a replacement part - so I can use it for my other skews?

Not to beat a dead horse - but:

I recently ran into this problem with the larger Lacer skew.
Perhaps Tormek should consider slightly enlarging their sharpening jig because of this popular tool.
Yes, it almost fits!!

My machine has a great deal of vibration at times when grinding chisels or plane irons. Pushing down on the outer end of the support helps some but not completely. This is at times a very coarse vibration!

What other measures can I take?