Jeff, how can I sharpen a pair of my wife's sewing scissors? They are not like the scissors you use to demonstrate the scissor jig. The blade of the scissor is angled besides the cutting angle. I cannot figure out how to mount them in the jig because there is no flat surface on the blade. Once in the clamp awkwardly, I cannot set the jig angle without the jig touching the stone as well(from behind the blade). Any suggestions you would have would be greatly appreciated.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com