I notice today as I sharpen my 12" planer blades they had a high spot in the middle of the blade. I went through all the steps to get the machine ready to sharpen the blades. I took the diamond truing tool the the wheel first. Then the stone grader to remove the grooves from truing the wheel. Follow by setting up the jig as per the manual. My thought is that my hand pressure is causing the high spot in the blades. Any other thoughts?
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Re: tormek shaft
February 12, 2014, 05:01:04 PM
Yes i am talking about the two nylon bearings for the main shaft. Thanks guys!
#3
General Tormek Questions / tormek shaft
January 24, 2014, 05:12:17 PM
On the shaft that the stone and leather wheel goes on to. Dose it need grease on the plastic pillow blocks? If so what grease should I use? I had to change the leather wheel this morning due to the old one coming apart.
#4
General Tormek Questions / Re:How would I sharpen a Veritas® Low-Angle Spokeshave?
September 11, 2004, 09:44:55 PM
I have the verision 6 hand book.
#5
Hand Tool Woodworking / Stanley No 4
June 10, 2004, 01:35:25 AM
What should the angle be on a stanley No.4 plane blade? thanks
#6
General Tormek Questions / How would I sharpen a Veritas® Low-Angle Spokeshave?
February 07, 2004, 10:03:42 PM
How would I sharpen a Veritas® Low-Angle Spokeshave?
Pages1