Hello everyone, I am new to the forum. I have been using T8 since 2020 with standard, CBN and diamond wheels, mostly on 8" kitchen knives and a little less on my folder collection. I was so happy when KS-123 came out because of the time economy compared to the Edding/sharpie method. I check my angles before and after sharpening with a laser goniometer. I experienced a consistent difference of 1 degree that the KS-123 is below the reading of my laser instrument. Can anybody in this forum confirm that difference by his own experience?
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Re: Is there a way to prevent the spacer coming off when swapping grinding wheels?
Today at 09:39:07 PM
Same problem here
Pages1