I have a T8 with an SG-250 waterstone. I have been using it for a while and just recently went to true the wheel. I noticed as I moved the carbide cutter from the inboard side to the outboard side that the cutting sound changed significantly. I have a flat stone, but now when I grind a chisel, the grinding sound is very different on each side. On the outboard edge, it sounds much coarser. I have tried the grading stone with no luck. Any ideas on what is going on?
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
General Tormek Questions / Uneven grit in SG-250
Today at 01:18:37 AMI have a T8 with an SG-250 waterstone. I have been using it for a while and just recently went to true the wheel. I noticed as I moved the carbide cutter from the inboard side to the outboard side that the cutting sound changed significantly. I have a flat stone, but now when I grind a chisel, the grinding sound is very different on each side. On the outboard edge, it sounds much coarser. I have tried the grading stone with no luck. Any ideas on what is going on?
Pages1