News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Werner Küspert

Pages1
#1
General Tormek Questions / chisel with 25 degrees in repeatable accuracy
Yesterday at 03:13:40 PM
I want to sharpen a large number of chisels at an angle of 25 degrees.
Does anyone have any advice on how I can set this angle for each chisel with repeatable accuracy?
Pages1