Thank you all for your assistance. Apparently I didn't scour hard enough and was able to order from the link provided by Ken S. Also good to know the thread size for future reference in case I need a quick replacement and can't wait for shippping. But let's hope I'm not so butter fingers going forward.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Tormek T-1 and T-2 / T1 replacement knob screw
September 03, 2025, 11:30:31 PM
Hello all, I recently acquired a T1 and then like an idiot, promptly lost the knob screw (part #1185) that holds the angle guide in place. I've scoured the internet looking for a replacement but can't seem to find one. Can someone direct to me where I can get a replacement? Or does someone know what the size of the screw is so then maybe I can just use a regular screw/bolt. Thank you all for your time.
Pages1