News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Dinosaur

#1
Knife Sharpening / Wheel direction
Yesterday at 09:10:19 PM
I'm kinda confused. I bought the Tormek T-8 with the knife angle setter and the knife jigs. I follow the tuturials the same as on the YouTube videos.

But the thing is, their wheel is turning away from them and the knife edge. But my wheel is turning toward me toward the knife edge.

I have the 600 grit diamond wheel. But that wheel will get damaged if I sharpen with the wheel grinding toward the edge.

So is there any way to reverse the spinning direction? Because obviously I can't sharpen knifes like this.