I have a T-4, and it has a mm scale on the machine label. I haven't found any directions on the use of this scale to measure the stone's diameter. But I suspect that laying a straight edge from the stone's grinding surface to the scale will point to the stone's diameter. Can anyone confirm this or correct me, please?
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
General Tormek Questions / Measuring Stone Diameter Using Scale on Machine Label
Yesterday at 09:57:24 PMPages1