Thanks, will try that. Terry
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
Planer Blade Sharpening / Re: Planer/Chisel Jig Chisel Not Turning Out Square
May 30, 2025, 08:44:08 AM #2
Planer Blade Sharpening / Re: Planer/Chisel Jig Chisel Not Turning Out Square
May 29, 2025, 09:59:30 AM
Many thanks for the advice. Terry
#3
Planer Blade Sharpening / Planer/Chisel Jig Chisel Not Turning Out Square
May 28, 2025, 08:24:19 PM
Hi, I have been using the jig on my grinding wheel on my Tormek T7 & using the planer/chisel jig, I made sure it was square in the holder, but my chisels are turning out slightly off square. Any advice would be much appreciated. Terry
Pages1