Thank you cbwx34
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
General Tormek Questions / Re: Tormek Angle Calvulator - Constant Value Verification Request
June 20, 2025, 06:51:20 AM #2
General Tormek Questions / Tormek Angle Calvulator - Constant Value Verification Request
June 17, 2025, 07:20:46 PM
Hello fellow grinders. I'm hoping someone can help me verify two required constant measurements when using angle calculators.
Are these measurements accurate?
Support Bar Offset: 50mm
Case Height: 30mm
Thank you in advance
Case Height
Are these measurements accurate?
Support Bar Offset: 50mm
Case Height: 30mm
Thank you in advance
Case Height
Pages1