News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Mander

Pages1
#1
General Tormek Questions / Re: Just bought a SuperGrind 2000, have a few questions
March 18, 2025, 08:26:49 PM
Herman, Thanks for your thoughts. I will look at the state of the honing wheel and see if some honing compound is needed. I have ordered the new 'US-105 Universal Support with Micro Adjust' and the 'TT50 - Truing and dressing tool'.
Best regards, Richard
#2
General Tormek Questions / Re: Just bought a SuperGrind 2000, have a few questions
March 17, 2025, 07:50:37 PM
Just a note to say these comments were very helpful in my work to start using a SuperGrind 2000 machine we have in our community workshop
Pages1