I have the subject knife sharpening jig. The only instruction regarding the positioning of the adjustable stop is to set it at 'zero'.
Why is it adjustable if it is always set to zero....?
Is it adjustable for a reason? I have not found any information for why or how it needs to be adjusted, except on the third page of the instructions.
Any enlightenment out there?
Thanks in advance
Lyle.
Why is it adjustable if it is always set to zero....?
Is it adjustable for a reason? I have not found any information for why or how it needs to be adjusted, except on the third page of the instructions.
Any enlightenment out there?
Thanks in advance
Lyle.